CLICK ON USED GEAR TO GO BACK

Item U31

SMPSU

SWITCH MODE REGULATED POWER SUPPLY UNIT

NEW MAINS POWER SUPPLY FOR NAGRA MONO, STEREO OR TIME CODE RECORDER,

NAGRA MODEL : - 111, IV.L, 4L , 4.2, E, D, IV.S / 4S, 4S T/C,

THIS IS AN EQUIVALENT POWER SUPPLY TO THE ATN NAGRA POWER SUPPLY AND WILL WORK IN ALL COUNTRIES

NOTE :- THIS UNIT IS OK FOR THE NAGRA 111,

IT WILL WORK FINE ON THE NAGRA 4L 4.2 OR 4S BUT THE TAPE REWIND SPEED WILL BE A BIT SLOWER THAN THE 35 VOLT ATN 2 or ATN 3 BUT STILL BETTER THAN WHEN ON BATTERIES

Note: I can supply an alternative mains lead with continental plug

THIS IS A SWITCH MODE REGULATED POWER SUPPLY THAT WORKS FROM 110 TO 240 VOLT AC 50Hz OR 60Hz MAINS SUPPLY, WITH A -24 VOLTS DC 1.75 AMP OUTPUT WITH A 6 PIN TUCHEL PLUG TO FIT THE NAGRA

THIS POWER SUPPLY IS NOT MADE BY NAGRA, AND DOES NOT HAVE THE EXTRA 1 VOLT 50Hz/60Hz PILOT OUTPUT SOCKETS, THAT IS NEEDED FOR OLDER NAGRA’S TO RUN IN SYNC SPEED WITH THE CAMERA, AS THIS 1-VOLT OUTPUT IS NO LONGER USED BECAUSE NAGRA’S AND CAMERAS HAVE INTERNAL CRYSTAL SYNC. THIS POWER SUPPLY IS ALL YOU NEED.

IF YOU HAVE AN OLD NAGRA OR ONE WITHOUT INTERNAL CRYSTAL AND NEED TO RUN IN 50Hz or 60Hz SYNC LOCK TO A PROJECTOR OR CAMERA, YOU WILL NEED AN ATN POWER SUPPLY WITH THE I VOLT PILOT AND OUTPUT LEAD.

NOTE: - THE POWER INPUT SOCKET ON YOUR NAGRA WILL GIVE YOU THE MINIMUM AND MAXIMUM VOLTAGE REQUIRED, IT WILL SAY FOR EXAMPLE (POWER PACK EXTERNAL -12 TO 25V OR -15 TO 30V ), IF - 24V IS WITHIN THE MIN & MAX, THIS POWER SUPPLY IS FINE. NOTE ALL NAGRA’S ARE (+) POSITIVE CASE / EARTH.

To buy this item please telephone:

MIKE HARRIS 01932 241948 and quote the reference number. For overseas callers

please dial +44 1932 241948